% % cweave.ch by Mark Motl for the purpose of separating the index % and module names into files INDEX.tex and MODULE_NAMES.tex % respectively. These are used in the web-mode for gnu-emacs. @x @* Introduction. The ``banner line'' defined here should be changed whenever \.{CWEAVE} is modified. @d banner "This is CWEAVE ($Revision: 1.9 $)\n" @y @* Introduction. The ``banner line'' defined here should be changed whenever \.{CWEAVE} is modified. @d banner "CWEAVE ($Rev: 1.9 $), writes INDEX.tex and MODULE_NAMES.tex\n" @z @x @ @c phase_three() { if (no_xref) { finish_line(); out_str("\\vfill\\end"); finish_line(); } else { phase=3; printf("\nWriting the index..."); if (change_exists) { finish_line(); @; } finish_line(); out_str("\\inx"); finish_line(); @.\\inx@> @; @; out_str("\\fin"); finish_line(); @.\\fin@> @; out_str("\\con"); finish_line(); @.\\con@> } printf("Done."); check_complete(); /* was all of the change file used? */ } @y @ @c phase_three() { if (no_xref) { finish_line(); out_str("\\vfill\\end"); finish_line(); } else { phase=3; printf("\nWriting the index..."); finish_line(); out_str("\\input INDEX"); finish_line(); finish_line(); out_str("\\input MODULE_NAMES"); finish_line(); fclose(tex_file); if ((tex_file=fopen("INDEX.tex","w"))==NULL) fatal("! Cannot open ouput file ","INDEX.tex"); if (change_exists) { @; finish_line(); finish_line(); } out_str("\\inx"); finish_line(); @.\\inx@> @; @; out_str("\\fin"); finish_line(); fclose(tex_file); @.\\fin@> if ((tex_file=fopen("MODULE_NAMES.tex","w"))==NULL) fatal("! Cannot open ouput file ","MODULE_NAMES.tex"); @; out_str("\\con"); finish_line(); fclose(tex_file); @.\\con@> } printf("Done."); check_complete(); /* was all of the change file used? */ } @z